Metrohm tiamo 2.4 Manual - Manual (Page 1279)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1263
Sample Processor: 730, 774, 778, 789, 814, 815, 864, 874
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command SCAN are configured in the following
dialog window:
￭ SCAN - Properties
Command variables
The following command variables are generated in the method run by the
command SCAN and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.TOU Timeout status: 1 = Timeout expired; 0 = Timeout
not expired
5.6.9.3.2 SCAN - Properties
Tab: Method ▶ SCAN ▶ Properties... ▶ SCAN - 'Command name'
Command name
Name of the command.
Entry 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.