Metrohm tiamo 2.4 Manual - Manual (Page 907)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 891
Appearance
The command has the following appearance:
Parameters
The parameters for the STAT U command are set on the following eight
tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
￭ Control parameters
Parameters for the control point.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definition of conditions which cause the titration to stop.
￭ Monitoring
Definition of the monitoring of measured value, dosing rate and tem-
perature.
￭ Evaluations
Definition of methods for evaluation of the titration curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands, which are saved as additional columns in the measuring point
list.
Command variables
The following command variables are generated by the STAT U com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
.BLV Blank value of the sensor used for the command (only
for ISE sensors)
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started