Metrohm tiamo 2.4 Manual - Manual (Page 171)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
tiamo 2.4
￭￭￭￭￭￭￭￭ 155
NOTE
When it is in the status READY, the start test can also be triggered
manually with the symbol or the menu items Tools
▶ Run test or
[Sample table] ▶ Run test…. In addition, the sample data test will
also still be carried out afterwards.
4 - Preconditioning (only for methods with conditioning)
For methods containing commands with conditioning activated, the pre-
conditioning is started for all these commands. The condition for this is,
that the option Automatic conditioning is activated in the START
command. The preconditioning is not part of the determination and incre-
ments no counter (Sample number, Statistics).
￭ Condition requirement not fulfilled
The status switches to COND BUSY after the start of the precondi-
tioning. In this status the conditioning can be interrupted with [Hold]
and be continued with [Cont]. If an error occurs during conditioning
neither the Error track nor the Exit track are run through.
￭ Condition requirement fulfilled
If the conditioning requirement has been fulfilled, then the status will
switch to COND READY. Afterwards, the method is started automati-
cally.
5 - Method start
The following checks and actions are triggered with method start:
￭ Assign determination ID
A unique determination ID is assigned for the determination.
￭ Reserve devices (modules)
The devices and/or their function units used by the device-dependent
commands of the method are reserved for the duration of the determi-
nation, i.e. they can neither be used in other workplaces nor can they
be operated manually.
￭ Increase sample number
The Sample number is increased by +1.
￭ Increase statistics counter
If the statistics is activated in the START command as well as on the
tab Determination series the statistics counter is increased by +1. If
a new method has been loaded or if the statistics counter corresponds
to the setpoint counter, the current statistics data is deleted before and
the statistics counter is set to 0.