Metrohm tiamo 2.4 Manual - Manual (Page 1025)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1009
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 933).
[Properties]
Opens the dialog window Calc. measured value # in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 933).
[Delete]
Deletes the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 934).
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Deletes the external measured value selected in the table.
5.6.4.9 MEAS Conc
5.6.4.9.1 MEAS Conc - Overview
Dialog window: Method ▶ MEAS Conc ▶ Properties... ▶ MEAS Conc - 'Command
name'
Command for Concentration measurements (direct measurement).
Instruments
This command can be executed with the following devices: