Metrohm tiamo 2.4 Manual - Manual (Page 27)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1 Introduction
tiamo 2.4
￭￭￭￭￭￭￭￭ 11
Instruments Firmware version
890 Titrando 5.890.0022
901 Titrando 5.901.0022
902 Titrando 5.902.0022
904 Titrando 5.904.0022
905 Titrando 5.905.0022
906 Titrando 5.906.0022
907 Titrando 5.907.0022
Manual program part
￭ Dosing devices and stirrers can now be controlled in the section of the
089 Photometer.
￭ In two-channel instrument setups, it is possible to control the flash rate
for the instrument for the measuring channel.
1.10.2 Improvements
General
￭ Starting with version 2.4, tiamo also runs on Windows 8 operating sys-
tem.
￭ The installation manual now contains a description of the directories
that can be stored in a network.
￭ E-mails can now be sent simultaneously to several recipients.
￭ The Calculation algorithms ▶ Statistics chapter in the online help
has been revised.
Workplace program part
￭ If an instrument required in the method does not exist, the message
009-032 Device not OK is displayed instead of 009-117 Device
not ok. The new message also contains the corresponding command
name, in addition to the instrument name.
￭ The determination of the transmission factor (MEAS TMF command)
has been optimized.
Database program part
￭ If a regular spectrum is measured with the Avantes spectrometer
(MEAS Spec), it is now possible to modify the evaluation areas during
the reprocessing of the determination.
￭ In the Calibration curve/Calibration data dialog window, the num-
ber of decimal places for Variance has been increased from 1 to 3 for
CAL LOOP pH, CAL LOOP Conc and ELT LOOP.