Metrohm tiamo 2.4 Manual - Manual (Page 1288)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1272 ￭￭￭￭￭￭￭￭
tiamo 2.4
Event/
Status Type Significance Com-
mands
End Event The command has just now been
ended. All
Dosing Event The dosing of the titration has just
now been started. DET,
MET
Measure Event The measurement of the titration
has just now been started. DET,
MET
Busy Status System is in status BUSY, HOLD or
ERROR. All
Finished Status The command is ended. In the event
that the command is run through
several times (e.g. within a LOOP),
the status FINISHED will be set
already after the first time the com-
mand is ended. All
Cond Status The command is currently in Condi-
tioning status (COND BUSY or
COND HOLD); the Start drift has
not yet been reached. SET, KFT,
KFC
Condok Status System is in Conditioning status
(COND READY); the Start drift
has been reached. SET, KFT,
KFC
NOTE
An event can only be received as such if the RECEIVE command has
been activated at the time of the event, i.e. it must have been started
prior to the respective event. The occurrence of an event is sent as a
system message, only "listeners" who are already active will receive this,
because it is not saved. A status, on the other hand, can be queried at
any time.
Comment
Comment on the event message
Entry 250 characters
Default value 'empty'