Metrohm tiamo 2.4 Manual - Manual (Page 756)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
740 ￭￭￭￭￭￭￭￭
tiamo 2.4
Parameters
The parameters for the SET Ipol command are set on the following eight
tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
￭ Control parameters
Control parameters for endpoint 1 and endpoint 2 (measured values
for the endpoints, titration rate, user-defined parameters, stop crite-
rion).
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definition of conditions which cause the titration to stop.
￭ Conditioning
Enable/disable conditioning. Definition of start drift, drift correction
and stop conditions.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration
curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands, which are saved as additional columns in the measuring point
list.
Command variables
The following command variables are generated by the SET Ipol com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identification Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CBY Command status; 1 = Conditioning activated, 0 =
Conditioning deactivated