Metrohm tiamo 2.4 Manual - Manual (Page 1060)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1044 ￭￭￭￭￭￭￭￭
tiamo 2.4
Smoothing
Number of neighboring pixels with which the value for each measurement
pixel is determined.
Input range 0 - 100 Pixels
Default value 0 Pixels
Flash rate
Number of flashes per second of a pulsed xenon lamp as light source.
Input range 0 - 100 Hz
Selection off
Default value off
off
For the continuous type of the light source.
5.6.4.13.4 MEAS Spec - Evaluations
Tab: Method ▶ MEAS Spec ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Entry 25 characters
The following additional methods for evaluation of measurement curves
can be activated and defined on this tab.
[New]
Opens the Evaluation window # dialog window for entering the start
and end wavelengths (see Chapter 5.6.4.13.5, page 1044).
[Properties]
Opens the Evaluation window # dialog window for editing the start
and end wavelengths selected in the table (see Chapter 5.6.4.13.5, page
1044).
[Delete]
Deletes the selected line.
5.6.4.13.5 MEAS Spec - Evaluation window
Dialog window: Method ▶ MEAS Spec ▶ Properties... ▶ Evaluations ▶ [New...]/
[Properties] ▶ Evaluation window #
Start wavelength
Lower limit of the evaluation range.
Input range 100.0 - 2,000.0 nm
Default value 400.0 nm