Metrohm tiamo 2.4 Manual - Manual (Page 1331)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4
￭￭￭￭￭￭￭￭ 1315
NOTE
For Windows 2000, proceed as follows for password monitoring by
Windows:
1. Start/execute "secpol.msc".
2. Under "Local Policies/User Rights Assignment", activate the "Act as
part of the operating system" policy for all desired user groups.
3. Restart the computer.
Maximum number of login attempts
If this check box is activated, then a user will be set to the disabled sta-
tus as soon as the number of login attempts defined here has been
exceeded. Signing (both methods and determinations) with a wrong pass-
word also counts as a failed login attempt. A user with the status disa-
bled can no longer start the program. The counter for login attempts is
reset to zero for all users with each restart.
Selection on | off
Default value off
FDA default: on (can no longer be edited)
Input range 2 - 5
Default value 3
Message by e-mail
If this check box is activated, then an e-mail will be sent to the address
defined under [E-mail...] as soon as the defined number of login
attempts has been exceeded.
Selection on | off
Default value off
[E-mail...]
This button opens the Send e-mail window (see Chapter 6.2.2.7, page
1321) for defining the e-mail parameters.
Logout policies
New login only for same user
If this check box is activated, then only the same user can log in again
after a manual logout. Users with administrator rights can always log in. If
this option is enabled, then the following option is automatically enabled
and inactive.
Selection on | off
Default value off