Metrohm tiamo 2.4 Manual - Manual (Page 689)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 673
5.6.3.3.6 MET Cond
5.6.3.3.6.1 MET Cond - Overview
Dialog window: Method ▶ MET Cond ▶ Properties... ▶ MET Cond - 'Command
name'
Command for Monotonic equivalence point titrations with conduc-
tometric measurement.
Devices
This command can be executed with the following instrument:
Conductivity Module: 856
Appearance
The command has the following appearance:
Parameters
The parameters for the MET Cond command are set on the following
seven tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
￭ Titration parameters
Parameters for the run of the titration.
￭ Stop conditions
Definition of conditions which cause the titration to stop.
￭ Conductometric evaluation
Parameters for the potentiometric evaluation of titration curves.
￭ Additional evaluations
Definition of additional methods for the evaluation of the titration
curves.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional columns in the measuring point
list.