Metrohm tiamo 2.4 Manual - Manual (Page 1436)

6.7 Sensors subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1420 ￭￭￭￭￭￭￭￭
tiamo 2.4
for ISE (+1)
Input range
–2.147E+9 - 2.147E+9 mV
Default value 62.4 mV
for ISE (–1)
Input range
–2.147E+9 - 2.147E+9 mV
Default value –55.0 mV
for ISE (+2)
Input range
–2.147E+9 - 2.147E+9 mV
Default value 32.7 mV
for ISE (–2)
Input range
–2.147E+9 - 2.147E+9 mV
Default value –26.7 mV
for ISE (+3)
Input range
–2.147E+9 - 2.147E+9 mV
Default value 22.7 mV
for ISE (–3)
Input range
–2.147E+9 - 2.147E+9 mV
Default value –16.7 mV
for ISE (+4)
Input range
–2.147E+9 - 2.147E+9 mV
Default value 17.8 mV
for ISE (–4)
Input range
–2.147E+9 - 2.147E+9 mV
Default value –11.8 mV
Warning limits for pH(0) (for pH electrodes only)
on | off (Default value: off)
If this option is activated, then the values for pH(0) will be shown in
orange if the limits are exceeded.
Lower limit
Lower warning limit for pH(0).
Input range –2.147E+9 - 2.147E+9
Default value 6.500
Upper limit
Upper warning limit for pH(0).