Metrohm tiamo 2.4 Manual - Manual (Page 858)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
842 ￭￭￭￭￭￭￭￭
tiamo 2.4
5.6.3.6.8 KFC - Additional evaluations
Tab: Method ▶ KFC ▶ Properties... ▶ Additional evaluations
Command name
Name of the command.
Entry 25 characters
The following additional method for evaluation of the titration curves can
be activated and defined on this tab:
Fixed endpoint evaluation
Fixed endpoint evaluation
on | off (Default value: off)
If this option is enabled, then the associated values for the other mea-
sured quantities will be interpolated with a fixed measured quantity (mea-
sured value, time or water) for the fixed endpoint from the measuring
point list.
Moves the selected line up (changes the sequence).
Moves the selected line down (changes the sequence).
[New]
Open the dialog window Fixed endpoint evaluation # to enter a new
fixed endpoint (see Chapter 5.6.3.6.10, page 844).
[Properties]
Open the dialog window Fixed endpoint evaluation # to edit the fixed
endpoint selected in the table (see Chapter 5.6.3.6.10, page 844).
[Delete]
Delete the selected line.
5.6.3.6.9 KFC - Additional measured values
Tab: Method ▶ KFC ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Entry 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings: