Metrohm tiamo 2.4 Manual - Manual (Page 746)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
730 ￭￭￭￭￭￭￭￭
tiamo 2.4
Input range 1 - 999 µL/min
Default value 20 µL/min
Delay time
If the endpoint has been reached, the delay time defined here is awaited
after the last dosing and then the titration is stopped. This parameter is
only shown for Stop criterion = time. The selection inf. stands for infin-
ite.
Titrando, 855
Input range
0 - 999 s
Default value 10 s
Titrino
Input range
0 - 999 s
Default value 10 s
Selection inf.
Stop time
The titration is stopped if the stop time defined here has elapsed since the
start of the titration. This parameter is only shown for Stop criterion =
time and Delay time = inf.
Titrino
Input range
0 - 999999 s
Selection off
Default value off
Endpoint 2
NOTE
Is active only for EP1 at ≠ off.
on | off (Default value: off)
Enable/disable endpoint 2. If this is disabled all following parameters are
not visible.
EP2 at pH
Measured value for the second endpoint.
Titrando, 855
Input range
-20.0 - 20.0
Selection off
Default value off