Metrohm 732 IC Detector - Manual (Page 126)

4.8 Data output
732 IC Detector / 733 IC Separation Center
119
4.8 Data output
4.8.1 <PRINT> key
PRINT
3
The <PRINT> key is used for the output of single measured values or
to start the automatic measured value output on an external printer or
PC connected to the RS232 interface. The output is triggered directly at
a keystroke, no inquiries appear.
Preparations
• For the output on an external printer, printer type and RS232 set-
tings must be correctly selected under <CONFIG> (see sec-
tion 4.4.2).
• For the output on a PC the character set under <CONFIG> ( "send
to: IBM" ) and the RS232 settings must be correctly selected see
section 4.4.2). For receipt of the data, a suitable program must be
started on the PC (e.g. Metrodata VESUV 2.1 or terminal program in
Windows accessories).
Elements of the measured value output
Depending on the parameter settings under " >CONFIG/print meas.
value " , the measured value output can comprise the following ele-
ments:
• Print header
The print header comprises a title line (device name, serial number,
program number), identifications 1 and 2 (if used) as well as the
date and time if desired (see section 4.4.2) and is outputted once,
always or never before a measured value output, depending on the
setting of the parameter " >CONFIG/printer/print header " .
• Run number
The run number (parameter " >CONFIG/auxiliaries/run number " ,
see section 4.4.2) is incremented by +1 and outputted on every
"INJECT A" (without program) or on every new start or " return " (with
program).
• Run time
The current time after the program start, after the last "INJECT A" or
after the instrument has been switched on is outputted before the
measured value.
• Measured value
The measured value shown in the display is outputted:
Measured value without sign Absolute conductivity
in µ S/cm or mS/cm
Measured value with sign Auto-zero value in µ S/cm,
%fs or mV
"--------" Measured value is >10%
outside the measuring range