Metrohm 732 IC Detector - Manual (Page 77)

4 Operation
732 IC Detector / 733 IC Separation Center
70
4.1.4 Flow chart for injection
The following flow diagram shows how an injection is started on the IC
system with and without a program. If the points <ZERO>, <FILL>
and "Siphoning in sample" are not programmed or must be performed
by the Autosampler, they must also be manually triggered. You will find
further information in the sections mentioned.
Program? Program?
yes yes
no no
End End
Start Start
New New
program? program?
yes yes
no no
Editing program Editing program sect. 4.7.1 sect. 4.7.1
Program Program
inactive? inactive?
yes yes
no no
Activating program Activating program sect. 4.7.1 sect. 4.7.1
Cycle Cycle
program? program?
yes yes
no no
<PROG R/S> <PROG R/S> sect. 4.7.2 sect. 4.7.2
Remote Remote
program? program?
yes yes
no no
Triggering remote start Triggering remote start sect. 6.2 sect. 6.2
Inject Inject
program? program?
yes yes
<INJECT> <INJECT> sect. 4.6.2/4.7.1 sect. 4.6.2/4.7.1
<ZERO> <ZERO> sect. 4.6.3 sect. 4.6.3
<FILL> <FILL> sect. 4.6.1 sect. 4.6.1
Siphoning in sample Siphoning in sample
<INJECT> <INJECT> sect. 4.6.2 sect. 4.6.2
Program execution Program execution
(n cycles with "cycle")
no no