Metrohm 732 IC Detector - Manual (Page 55)

3 Operating tutorial
732 IC Detector / 733 IC Separation Center
48
3.3 Putting into operation
After the complete IC system has been installed as described in sec-
tion 3.2, it can be put into operation. In what follows, all operating steps
up to the first calibration with the standard solution are described in se-
quence.
Please note that all displays refer to the condition in which the instru-
ment was put into operation for the first time (initial condition). If you do
not run through this tutorial until a later date, differences in regard to the
dialog language and the parameter values can appear. How you return
to the initial condition in such a case is described in section 5.4.9.
In this description of putting the instruments into operation, it is as-
sumed that all instruments are shut down and must first be switched
on. If this is not the case (e.g. if you start the operating tutorial immedi-
ately following the conditioning), you can skip steps 1 1 – 3 3.
1 Switch on external devices
⇒ Switch on recorder (if used).
⇒ Switch on «IC Metrodata for Win95» and PC
(if used).
⇒ Switch on other recording and evaluation system
(if used).
2 Switch on 709 IC Pump
⇒ Switch on 709 IC Pump with mains switch 29 29
(see section 2.6.4 of the 709 Instructions for Use).
3 Switch on remote control for 709 IC Pump
(the pump must be connected to the 732 IC Detector with a
6.2125.060 RS Cable for this)
⇒ Set sliding switch 36 36 at the rear of the 709 IC Pump to " RS
232 " (see Fig. 2 of the 709 Instructions for Use).
⇒ Press key 88 <EXT.> on the 709 IC Pump to switch on the
external control (see section 3.6 of the 709 Instructions for
Use).
When the external control is activated, LED 77 above the
<EXT.> key lights up. All keys of the 709 IC Pump with the
exception of the <SELECT> key are blocked, operation is
now possible only via the 732 IC Detector.