Metrohm 732 IC Detector - Manual (Page 131)

4 Operation
732 IC Detector / 733 IC Separation Center
124
4.8.3 <REPORT> key
REPORT
2
The <REPORT> key is used for the output of reports on an external
printer or PC connected to the RS232 interface.
The <REPORT> key opens the following inquiry:
XXXXXX µµS/cm XXXX min
report: all
all, config, event,
method, method list,
param, program, pump
Selection of the report
Selection of the report which should be outputted:
all All reports in the order " config, event,
method, method list, pump "
config Configuration report (parameters of the
<CONFIG> key)
event Event report (parameters of the
<EVENT> key)
method Method report (comprises method name,
parameter and program report)
method Method list (details of stored
list methods)
param Parameter report (parameters of the
<PARAM> key)
program Program report (parameters of the
<PROGRAM> key)
pump Report of the pump parameters
Example of "config" report
Configuration for 732 IC Detector with attached Seiko printer and 733.0010
IC Separation Center with 1 injection valve
CONFIG
>CONFIG/detector
thermostat: 35 °C
'zero' unit:
µ S/cm
cell constant 16.7 /cm
>CONFIG/printer
id.1 PRP-X100
id.2 drinking water
print header: once
date&time: on
send to: Seiko
>CONFIG/print meas.value
print crit.: time
time interval 300.0 s
stop time 60 min
date&time: off
>CONFIG/auxiliaries
run number 0
number of cycles 1
>CONFIG/aux/event
enabled in program: off
date 1995-10-10
time 11:38:20
dialog: english
device label
program 732.0012
>CONFIG/aux/beeper
status: on
repeat time 60 s
>CONFIG/RS settings
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
control via RS: on
>CONFIG/RS settings 709
baud rate: 9600
>CONFIG/733 IC Sep.Cent.
valve A
control: no restriction
>CONFIG/733/valve A
status inject
trigger: inject
--------------