Metrohm 732 IC Detector - Manual (Page 60)

3.3 Putting into operation
732 IC Detector / 733 IC Separation Center
53
If you wish to change the displayed time, enter the new
numeric values in the order hours – minutes – seconds us-
ing the numeric keys, e.g. " 08:32:00 " . The new time does
not become active until you confirm it by pressing the
<ENTER> key.
ENTER
⇒ Confirm the new time by pressing the <ENTER> key.
>CONFIG/auxiliaries
dialog: english
The display now shows the selection of the dialog lan-
guage, which is set to " english " , as the next inquiry.
The character " : " again appears with this display. This
means that values must be selected from preset values
using the <SELECT> key.
SELECT
⇒ Press the <SELECT> key to select the next language
setting.
>CONFIG/auxiliaries
dialog: deutsch
" deutsch " is now selected as the dialog language.
ENTER
⇒ You could confirm this language setting by pressing the
<ENTER> key to immediately switch the dialog language
to " deutsch " (or any other language you have selected),
but instead:
>CONFIG/auxiliaries
device label
Use the <SELECT> key to move through the selection
back to " english " and confirm with the <ENTER> key.
The display shows the device label as the next inquiry.
However, at present we are not interested in the further
inquiries of this submenu.
QUIT
⇒ Press the <QUIT> key.
CONFIG
>CONFIG/auxiliaries
You now quit the inquiries and return to the title of the
submenu " auxiliaries " .
QUIT
⇒ Press the <QUIT> key again to return to the standby mode
of the instrument.
151.2 µµS/cm 4.3 min
method DEFAULT
The 732 IC Detector is now again in the standby mode and
the display shows the status messages.