Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1017)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1001
5.6.4.16 STDADD dos
5.6.4.16.1 STDADD dos - Overview
Dialog window: Method ▶ STDADD dos ▶ Properties... ▶ STDADD dos - 'Command
name'
Command for Standard addition with addition of the standard addition
solution from a dosing device.
Devices
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 857, 904, 905, 906, 907
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command STDADD dos are configured on the fol-
lowing 3 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Standard addition
Parameters for standard addition.
￭ Measuring parameters
Parameters for setting the measurement procedure.
Standard addition curve
The standard addition curve with its associated evaluation data for a deter-
mination is shown in the program part Database in the dialog window
Calibration curve, which is opened with the menu item Determina-
tions
▶ Show calibration curve... or the symbol .
Command variables
The following command variables are generated in the method run by the
command STDADD dos and can be used in formulas under the designation
'Command name.Variable designation':