Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1381)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 6 Configuration
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1365
￭ Special beakers
Display of the special beaker for the rack in position.
6.11.3.7 Properties - Lift positions (774)
Dialog window: Configuration ▶ Rack data ▶ Properties
Tower 1
Defines the lift positions for Tower 1. These apply for all rack positions except
those that are defined as (see Chapter 6.11.3.8, page 1365).
Work position
Work position for Lift 1. At this lift position the electrodes, stirrer and buret
tips are optimally positioned for work.
Range 0 ... 100 mm
Rinse position
Rinse position for Lift 1. This lift position is used for rinsing the electrodes.
Range 0 ... 100 mm
Shift position
Shift position for Lift 1. Each time that the rack shifts, the lift will move to
this position if it is located at a lower lift position. If the lift is located at a
higher lift position than that defined here, then the shifting will take place
at the current lift position. This means that the shift position must be selected
so that a safe movement across the entire rack is possible at any time.
Range 0 ... 100 mm
Special position
Special position for Lift 1. This additional definable position can be used e.g.
during pipetting so that the tip is just immersed in the sample solution.
Range 0 ... 100 mm
6.11.3.8 Properties - Special beaker (774)
Dialog window: Configuration ▶ Rack data ▶ Properties
Special beaker
Shows the number of the special beaker for the selected rack.
Rack position
Shows the number of the rack position for the special beaker.