Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 589)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 573
.BP{x}.MEA Measured value for the break point × (1…9) in the unit
of the measured value
.BP{x}.TEM Temperature for the break point × (1…9) in °C
.BP{x}.TIM Time for the break point × (1…9) in s
.BP{x}.VOL Volume for the break point × (1…9) in mL
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CONC Concentration of the solution used for the command
.CYL Cylinder volume of the exchange or dosing unit used
for the command
.DBL Total duration for the processing of the command in s
.DSC Time for processing all start conditions s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.ENP Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.EP{x}.DME Measured value differential for the endpoint × (1…9)
.EP{x}.MEA Measured value for the endpoint × (1…9) in the unit
of the measured value
.EP{x}.MEP Quantity of endpoints in the window × (1…9); 1 = 1
endpoint, 2 = 2 or more endpoints, 3 = EP cor-
rected with Autodrift, 4 = EP corrected with
manual drift
.EP{x}.TEM Temperature for the endpoint × (1…9) in °C
.EP{x}.TIM Time in s until the endpoint × (1…9) is reached
.EP{x}.VOL Volume for the endpoint × (1…9) in mL
.ETE End temperature (temperature following processing of
the command) in °C
.EVT End volume (total dosed volume at the end of the com-
mand) in mL
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.FP{x}.DME Measured value differential for the fixed endpoint Ч
(1…9)