Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 979)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 963
Identification Description
.MI.MEA Minimum measured value (U
ind
) in mV
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.RTE Reference temperature in °C
.STY Type of stop with which the command was stopped:
1 = normal;0 = manual or after error
.TC.TC Temperature coefficient in %/°C
.TC.CO Coefficient c0 of the Chebyshev polynomial of the sol-
ution used
.TC.C1 Coefficient c1 of the Chebyshev polynomial of the sol-
ution used
.TC.C2 Coefficient c2 of the Chebyshev polynomial of the sol-
ution used
.TC.C3 Coefficient c3 of the Chebyshev polynomial of the sol-
ution used
.TC.C4 Coefficient c4 of the Chebyshev polynomial of the sol-
ution used
.TC.TSTART Start temperature in °C
.TC.TSTOP Stop temperature in °C
5.6.4.10.2 MEAS Cond - General/Hardware
Tab: Method ▶ MEAS Cond ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device and the sensor are defined on this
tab.
Device
Device name
Selection of a device from those available in the device table. The only devi-
ces which shall be offered are those with which the command can run.