Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 345)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 329
4.5.2.14 Determinations - Displaying history
Menu item: Database ▶ Determinations ▶ Show history
Switch history view on/off
With the menu item Determinations
▶ Display history... or the symbol
only the currently focused determination in the Determination table as
well as all the previous versions of this determination will be shown.
If the History view with the menu item Determinations ▶ Display his-
tory... or the symbol is disabled again, then the original selection of
determinations in the Determination table will appear again.
4.5.2.15 Determinations - Make current
Menu item: Database ▶ Determinations ▶ Make current
Make old version current
With the menu item Determinations
▶ Make current... or the symbol
the determination version selected in the determination table will again
be made the current determination version. This creates a new determina-
tion whose version number is increased by +1 compared with the last version
to have been saved.
4.5.2.16 Determinations - Show calibration curve
Dialog window: Database ▶ Determinations ▶ Show calibration curve… ▶ Calibra-
tion curve/Calibration data
With the menu item Determinations, Show calibration curve... or the
symbol the calibration or standard addition curve is shown for the cali-
bration selected in the dialog window Calibration curve/Calibration
data.
Calibration curve for CAL LOOP pH
In the dialog window Calibration curve/Calibration data a tab marked
with the command name showing the calibration curve and calibration data
will be displayed for each CAL LOOP pH command (see Chapter 5.6.5.4,
page 1021). The command type is shown above the calibration curve. The
curve display shows the measured values and the curve calculated from
these measured values. Listed below are the individual measured values and
the results for Slope, E(0) and Variance.
Calibration curve for CAL LOOP Conc
In the dialog window Calibration curve/Calibration data a tab marked
with the command name showing the calibration curve and calibration data
will be displayed for each CAL LOOP Conc command (see Chapter
5.6.5.6, page 1040). The command type is shown above the calibration
curve. The curve display shows the measured values and the curve calculated