Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 321)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 4 Database
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 305
4.5.2.6.3 Reprocessing rules
Dialog window: Reprocess
The following rules apply for reprocessing the selected and modified deter-
minations:
￭ Number of determinations
No more than 100 determinations (including statistically linked determi-
nations) may be selected for reprocessing.
￭ Statistically linked determinations
If determinations are selected for reprocessing that are statistically linked
with other determinations that have not been selected then these deter-
minations will also be automatically reprocessed when saving and then
saved as new versions. Determinations that are statistically linked with
each other must always be reprocessed in the same sequence as they
were recorded. If no modification is made to a determination then this
determination will retain its original determination status (i.e. original
for non-modified determinations).
Note
If the selected determination belongs to a statistics series still running, the
results modified during reprocessing will not be taken into account in the
automatically generated reports of the following determinations of the
statistics series.
In this case, the end of the statistics series has to be waited for. After this,
all determinations of the statistics series contain the right results and the
original reports can be printed from the database.
￭ Start test
During the start test all device tests and device monitoring will be ignored.
￭ Special tracks
During reprocessing the series start, series end and error tracks are not
run through again.
￭ Tracks with "Return immediately"
If the method contains tracks with the option Return immediately
enabled, then a warning will appear, that it can no longer be guaranteed
that the method will proceed in the same way during reprocessing as
during the determination itself.
￭ Monitoring If the method contains monitoring of variables and results
then the corresponding messages will be shown and included in the
report, but no E-mails will be sent nor will beeps be produced. If one of
the two actions Stop determination or Stop determination and
series is enabled, then reprocessing will be canceled.