Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 1189)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.2 (ProcessLab) ￭￭￭￭￭￭￭￭ 1173
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the device
type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types or
device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | RS-232 device
Default value RS-232 device
Transfer commands
The Transfer commands defined in the dialog window are sent in the
sequence in which they are listed. The table cannot be edited directly.
Note
10 transfer commands can be entered at maximum.
Moves the selected command up (changes the sequence).
Moves the selected command down (changes the sequence).
[New]
Opens the dialog window Transfer command for entering a new transfer
command (see Chapter 5.6.9.6.3, page 1174).
[Properties]
Opens the dialog window Transfer command for editing the transfer
command selected in the table (see Chapter 5.6.9.6.3, page 1174).
[Delete]
Deletes the selected transfer command.
Timeout
on | off (Default value: off)
If this option is activated, then a maximum waiting time can be entered. If
not all transfer commands have finished after this time period, the command
is canceled and the next command is started.
Range 0 ... 9999.9
Default value 1