Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 142)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
126 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
defined in the method can be enabled and disabled manually here (only in
the status READY and COND BUSY).
The first field after Statistics shows the number of determinations already
carried out for the statistics (Actual counter). This field cannot be edited, but
when it is in the status READY, it can be set to 0 with the context sensitive
menu item Delete statistics, whereby the already calculated statistics data
is deleted at the same time.
The second field after Statistics shows the number of determinations still
to be carried out for the statistics (Setpoint counter). In its default settings,
it contains the value Number of single determinations defined in the
START command. This field cannot be edited except in the status
READY and COND BUSY.
Note
When a new statistics series is started, the setpoint counter will be reset
to the value defined in the START command.
3.6.3.5 Single determination - Sample data
Tab:Workplace ▶ Run ▶ Single determination
Method
Entry or selection of the method from the current method group with which
the determination is to be carried out. By typing in the first characters, the
method selection is continuously restricted and allows fast selecting of the
method required.
Input 50 characters
Selection Method selection
Open the dialog window Open method for the extended method selection.
If a method is selected in this window from a method group other than the
current one, then this group will henceforth be the current method group
for the quick selection of methods in the Method field. This button is active
only if more than one method group is present.
Note
If a method is changed and saved in the method editor or during reproc-
essing, then the latest method version will be loaded when a new
determination is started.