Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 138)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
122 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
3.6.2 Run test
Menu item: Workplace ▶ Tools ▶ Run test
Note
In contrast to the Sample table test, which is only used to check
whether or not all sample data is correct, the Run test also checks the
required hardware.
Single determination
The menu item Tools
▶ Run test or the symbol is used to perform the
start test for the selected method. The precondition for this is that the work-
place is in READY status.
For the Run test, the dialog window Run test - 'Workplace name' - Sin-
gle determination opens, in which information concerning the test is
displayed.
Method
Displays the method for the single determination.
Determination series
The menu items Tools
▶ Run test or [Sample table] ▶ Run test… or the
symbol are used to perform the Start test. The precondition for this is
that the workplace is in READY status. The Start test is however performed
only for the number of lines defined under Autostart.
For the Run test, the dialog window Run test - 'Workplace name' -
Determination series opens, in which information concerning the test is
displayed.
Line
Displays the line number of the currently tested sample data line for the
determination series.
Status displays
One of the following status displays appears underneath the line number:
Selection Run test running… | Run test error | Run test
finished without errors
Run test running…
This display appears during the test run. A progress bar also appears; the
test can be interrupted thereby by means of the [x] next to the bar.