Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 152)

3.6 Subwindow Run ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
136 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
Request assignment ID
on | off (Default value: off)
If this option is enabled, the Assignment ID will be queried immediately
after the start of the determination.
Autorepeat determination
on | off (Default value: off)
If this option is enabled, then the next determination will be started with the
same method automatically after the completion of a determination. The
determination must be canceled with [Stop] in order to cancel the auto-
matic repetition.
3.6.3.9.5 Properties - Data import
Tab: Workplace ▶ Run ▶ Single determination ▶ Properties Run window ▶ Prop-
erties - Single determination ▶ Data import
Enabling/disabling the import of external data for fields on tab Single
determination.
Note
The successful conclusion of the data import during the run will be sig-
naled by an acoustic signal (beep).
Import from balance
on | off (Default value: off)
If this option is enabled, then external data from the selected balance will
be imported into the fields on the tab Single determination. Data can be
imported into the fields ID1…ID4, Sample size and Unit.
Note
In order to be able to import sample identifications from the balance, data
export must be set accordingly at the balance (Use designations ID1,
ID2, ID3, ID4).
Balance
Selection of the balance from which data is to be imported.
Selection Device name