Metrohm tiamo 2.2 (ProcessLab) - Manual (Page 378)

4.8 Subwindow curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
362 ￭￭￭￭￭￭￭￭ tiamo 2.2 (ProcessLab)
The column Monitoring is displayed as default for STAT and DOS com-
mands and can contain the following entries:
Selection _Meas.v. | ¯Meas.v. | _Dos.r. | ¯Dos.r. | _Temp. |
¯Temp. | *
Default value *
_Meas.v.
Lower limit value for measured value monitoring exceeded.
¯Meas.v.
Upper limit value for measured value monitoring exceeded.
_Dos.r.
Lower limit value for dosing rate monitoring exceeded.
¯Dos.r.
Upper limit value for dosing rate monitoring exceeded.
_Temp.
Lower limit value for temperature monitoring exceeded.
¯Temp.
Upper limit value for temperature monitoring exceeded.
*
Dosing stopped.
4.8.2 Curves - Measuring point list
Dialog window: Database ▶ Curves
With the context-sensitive menu item Measuring point list... in the curve
window the dialog window Measuring point list - 'Command
name.#' opens for showing the measuring point list for the selected curve.
The display of the measuring points in the table can be defined per window
and per command type in the Properties - Curve #
4.8.3 Curves - Monitoring report
Dialog window: Database ▶ Curves
If the method contains commands of the type STAT or DOS, then with the
context-sensitive menu item Monitoring report... in the curve window the
dialog window Monitoring report - 'Command name' can be opened.
In this window information on limit violations occurred are displayed for
each monitoring switched on
The following columns are displayed:
Time [s]
Time in s until limit violation.
Limit
Selection lower | upper | ok