Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 38)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
VIRTUAL TERMINAL SYSTEM MODES / 29
VIRTUAL TERMINAL SYSTEM MODES
The Virtual Terminal has two modes of operation:
• Operate (master/control switch ON)
• Setup-accessible only with password (master/control switch OFF)
OPERATE MODE
When the master/control switch is in the ON position, the Virtual Terminal
(VT) is in Operate mode. In this mode, all enabled system components and
control channels are operational, as well as all monitoring functions and
system accumulators.
Figure 30
Main Menu in Operate Mode
OPERATE MODE BUTTONS
Virtual buttons on the display are used to interact with the system.
Top-level buttons that appear on the Operate and Setup/Configuration
screens are defined below.
NEXT CHANNEL
Selects the next available channel for changes of rate or to turn channel off.
This button is visible only when multiple channels have been configured.
• The active channel can be set to ON or OFF by selecting the On/Off
Channel button described below.
• The active channel is displayed in reverse video display in a multiple
channel configuration.
• The Target Rate for a channel can be adjusted by using the Inc/Dec
buttons described below.
• The channel’s Inc/Dec buttons, as well as the ON/OFF buttons, display
the current channel label.