Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 42)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
USER LEVELS / 33
USER LEVELS
The system has two user levels that allow access to certain screens based
on user level type.
• User Level 1 Operator (Basic View)
• User Level 2 OEM/Dealer (Full Access)
At initial powerup, the system loads in User Level 2. The system can be
locked at User Level 1 and will continue to load at this level at every power
cycle. A password is required to return to User Level 2 screens.
USER LEVEL 1 OPERATOR (BASIC VIEW)
Operator View (User Level 1) is a restricted level that does not allow any
setup/configuration constants to be changed. In operator view the following
functions can be performed:
• Perform a fill disk
• Increase and decrease rates
• Turn on/off a control channel
• Access Diagnostics screen
• Access/view Information screen
• Access/view Alarm Log and Detail screens
All other screens for configuring and setup of constants must be performed
in Level 2 mode.
To change to User Level 1 Mode (Basic Operator View):
1. Press the Top Menu button.
– At the Main Work screen, press the Work Screen button to access
the Top Menu button.
2. At the Top Menu screen, press the Next Page button.
3. Press the Information button.
4. At the Information screen, press the Password button.
– At the Password screen, text at screen bottom states “Dealer
screens on” in the User Level 2 (Full Access) mode.
5. Press the Lev 1 Lock button. The Lev 1 Lock button will disappear
from the screen and the system will now operate in Level 1 mode.
6. Press the Work Screen button to return to the Main Work screen.
The system will return to the previous set level at each power cycle until
changed at the Password screen.