Channel setup, Operator’s manual, Setting channel parameters – Great Plains DICKEY-john MVT Monitor Operator User Manual
Page 52
OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
CHANNEL SETUP / 43
CHANNEL SETUP
Channel Setup allows configuration of two independent control channels.
Control channel parameters include:
•
Control Mode
•
Drive Type
•
Drive Frequency
•
Input Filter
•
Gear Ratio
•
Sensor Constant
•
# Seed Rows
•
Channel Width
•
Precharge Time
•
Delay Time
•
Flush Time
SETTING CHANNEL PARAMETERS
To Setup a Control Channel:
1. Press the Top Menu button to display the Setup screen.
2. Press the Controls button.
– To configure more than one control channel, press the Next
Channel button.
– A channel identified as Disabled indicates the channel is not in
use.
3. At the Materials screen, use the rotary button to highlight each yellow
input box.
4. Push in the rotary button to select or change the value.
5. Push in the rotary button again to accept the change.
6. Press the More button for additional parameters.
Figure 41
Control Channel Setup
MATERIAL NAME
Select the material assigned to the channel. Press the Materials button to
create a new material.