Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 97)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
88 / CUSTOMIZING THE WORK SCREEN
CHANNELS 1 - 2 AREA
Channels 1 - 2 Area displays the area covered by Control Channels 1 - 2.
Area is calculated using the Channel Width parameter that is entered on the
Control Setup screen. Area accumulates when the master/control switch is
ON and the ground speed is above the Shutoff Speed parameter entered
on the Ground Speed Calibration screen. This accumulator is
independent of any other area accumulator and can be reset to 0.0 at any
time. Current area is retained after power down.
AREA SCAN
Area Scan scans through all area accumulators sequentially displaying the
area for each accumulator in four-second intervals.
CONTROL FEEDBACK SCAN
Feedback Scan scans through all active control channel feedback sensors
sequentially displaying the actual RPM or GPM measured in four-second
intervals. The current sensor is identified by the number displayed above
the RPM symbol (planter control, granular seeding, granular fertilizer) or
GPM symbol (liquid flow).
AREA PER HOUR
Area Per Hour displays the current area per hour in acres (Ha). The value is
continuously calculated based on the current ground speed and the
implement width parameter as entered on the Row Setup screen.
SYSTEM ACTIVE TIME
System Active Time records the amount of time the master/control switch is
in the ON position indicating the actual number of hours equipment has
been operating.