Operator’s manual, Rpm sensor setup – Great Plains DICKEY-john MVT Monitor Operator User Manual
Page 78
OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
ACCESSORY SENSORS / 69
RPM SENSOR SETUP
The RPM Setup screen controls the parameters for each RPM sensor:
•
High alarm
•
Low alarm
•
High alarm delay
•
Low alarm delay
•
RPM constant
•
RPM filter
•
Disable control on low alarm
The RPM Setup button only displays on the Accessory screen when a
value is entered.
RPM sensors must be configured manually and will not auto populate
using the Auto Configuration button.
1. Press the RPM Setup button to access the RPM Setup screen.
2. Highlight the yellow input box and push in the rotary dial to open
keypad and set the desired values.
3. Press the OK button and push in rotary dial to accept..
Figure 59
RPM Setup Screen
NOTE:
Only modules that can support
accessory sensors are
displayed on the Accessory
Assignment screen.