Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 41)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
32 / VIRTUAL TERMINAL SYSTEM MODES
CONTROLS
Enter data relative to the control channel based on user preferences for 2
control channels.
MATERIALS
Configure and store up 16 different materials for planter control.
SPEED SET
Accesses the Ground Speed Setup screen and allows adjustment of the
ground speed in MPH (Km/h) as measured by the ground speed sensor.
PLANTER FILL DISK
Fills the seed meters to allow instant seed flow when the channel is turned
ON. Pressing the Fill Disk button rotates the seed meters on ALL ACTIVE
planter control channels one revolution, then stops. For additional
information, refer to the System Configuration section.
SYSTEM ACCUMULATORS
Displays all of the system accumulators for time and distance. There is no
user-entered data on this screen.
SCREEN CONFIGURATION
The Virtual Terminal can be customized to display any combination of data
items available. Up to three individual display screens can be customized.
All work screen configurations are established on this screen.
INFORMATION
Displays the module software versions connected to the system and is
typically used for troubleshooting. Each module connected is identified by
module type, module position, and serial number. Module position cannot
be altered on this screen and can only be established on the Module
Configuration screen.
DIAGNOSTICS
Various system operating parameters display on this screen. There is no
user-entered data on this screen.
ALARM LOG
A listing of previous alarms that have occurred display on screen. There is
no user-entered data on this screen. Not all alarms are recorded in the
alarm log.