Great Plains DICKEY-john MVT Monitor Operator - Manual (Page 39)

OPERATOR’S MANUAL
IntelliAg MVT
11001-1643-201401
30 / VIRTUAL TERMINAL SYSTEM MODES
NEXT WORK SCREEN
Displays information on the next available work screen. The number to the
left of the graphic identifies the current screen. The number on the right
identifies the next screen to display. The Next Work Screen is only visible
when multiple screens are configured.
INCREMENT
Increases the active channel’s target rate by the amount specified in the
Inc/Dec % or rate table setup for that material. Increment can be pressed
several times to increase the target rate by the specified amount for every
actuation, until the maximum rate value or preset value is reached. The
active channel/material is displayed in the button text.
DECREMENT
Decreases the active channel’s target rate by the amount specified in the
Inc/Dec% or rate table setup for that material. Decrement can be pressed
several times to reduce the target rate by the specified amount for every
actuation, until the minimum rate value or preset value is reached. The
active channel/material is displayed in the button text.
INC/DEC RESET TO TARGET
Returns the active channel to the original material target rate. This button is
only available for channels that are active and have had the target rate
adjusted using the Increment or Decrement buttons in inc/dec % mode.
The active channel displays in the button text.
TOP MENU
Provides an overview screen of how the system is setup including
channels, rows, ground speed, accessory sensors, and implement lift
status. Also, access to Setup screens is completed using the buttons on
the Top Menu screen.
CONTROL ON/OFF CHANNEL
The active channel can be turned either ON and OFF by pressing this
button. Channels that are set to OFF will not operate when the master/
control switch is set to the ON position. Turning a channel OFF is not the
same as disabling a channel in Channel Setup mode. The active channel is
displayed in the button text. If the button text is OFF, this is the action that
occurs when the button is pressed.