Dell POWEREDGE M1000E - Manual (Page 1025)

39-25
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 39 Configuring IPv6 Unicast Routing
Configuring IPv6
Enabling HSRP Version 2
Beginning in privileged EXEC mode, follow these steps to enable HSRP version 2 on a Layer 3 interface.
Enabling an HSRP Group for IPv6
Beginning in privileged EXEC mode, follow these steps to create or enable HSRP for IPv6 on a Layer 3
interface.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Enter interface configuration mode, and enter the
Layer 3 interface on which you want to specify the
standby version.
Step 3 standby version {1 | 2} Enter 2 to change the HSRP version. The default is 1.
Step 4 end Return to privileged EXEC mode.
Step 5 show standby Verify the configuration.
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Enter interface configuration mode, and enter the Layer 3
interface on which you want to enable HSRP for IPv6.
Step 3 standby [group-number] ipv6 {link-local-address
| autoconfig} Create (or enable) the HSRP for IPv6 group.
• (Optional) group-number—The group number on the
interface for which HSRP is being enabled. The range is 0
to 4095. The default is 0. If there is only one HSRP group,
you do not need to enter a group number.
• Enter the link-local address of the Hot Standby router
interface, or enable the link-local address to be generated
automatically from the link-local prefix and a modified
EUI-64 format interface identifier, where the EUI-64
interface identifier is created from the relevant HSRP
virtual MAC address.