Dell POWEREDGE M1000E - Manual (Page 116)

4-8
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 4 Configuring Cisco EnergyWise
Managing Single Entities
Powering the PoE Port
Beginning in privileged EXEC mode:
Configuring PoE-Port Attributes
Beginning in privileged EXEC mode:
Step 10 show energywise
show energywise domain
Verify your entries.
Step 11 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Specify the port or the range of ports to be configured, and enter
interface configuration mode.
Step 3 energywise level 0
or
energywise level 10
(Optional) Manually power off the port, or
Manually power on the port.
Step 4 end Return to privileged EXEC mode.
Step 5 show energywise domain
show energywise children
Verify your entries.
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.
Note The power level that you set in Step 3 is the default power
level when the switch restarts.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface interface-id Specify the port or the range of ports to be configured, and enter
interface configuration mode.
Step 3 energywise importance importance (Optional) Set the importance of the port.
The range is from 1 to 100.
The default is 1.