Dell POWEREDGE M1000E - Manual (Page 13)

Contents
xiii
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Disabling IEEE 802.1x Authentication on the Port 10-66
Resetting the IEEE 802.1x Authentication Configuration to the Default Values 10-66
Displaying IEEE 802.1x Statistics and Status 10-67
C H A P T E R
11 Configuring Interface Characteristics 11-1
Understanding Interface Types 11-1
Port-Based VLANs 11-2
Switch Ports 11-2
Access Ports 11-3
Trunk Ports 11-3
Tunnel Ports 11-4
Routed Ports 11-4
Switch Virtual Interfaces 11-5
SVI Autostate Exclude 11-5
EtherChannel Port Groups 11-6
10-Gigabit Ethernet Interfaces 11-6
Connecting Interfaces 11-7
Using Interface Configuration Mode 11-8
Procedures for Configuring Interfaces 11-9
Configuring a Range of Interfaces 11-10
Configuring and Using Interface Range Macros 11-11
Using the Internal Ethernet Management Port 11-13
Understanding the Internal Ethernet Management Port 11-13
Supported Features on the Ethernet Management Port 11-15
Layer 3 Routing Configuration Guidelines 11-16
Monitoring the Ethernet Management Port 11-16
TFTP and the Ethernet Management Port 11-17
Configuring Ethernet Interfaces 11-17
Default Ethernet Interface Configuration 11-17
Configuring Interface Speed and Duplex Mode 11-19
Speed and Duplex Configuration Guidelines 11-19
Setting the Interface Speed and Duplex Parameters 11-20
Configuring IEEE 802.3x Flow Control 11-21
Configuring Auto-MDIX on an Interface 11-22
Adding a Description for an Interface 11-23
Configuring Layer 3 Interfaces 11-24
Configuring SVI Autostate Exclude 11-25
Configuring the System MTU 11-26
Monitoring and Maintaining the Interfaces 11-28