Dell POWEREDGE M1000E - Manual (Page 558)

22-16
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 22 Configuring DHCP Features and IP Source Guard
Displaying DHCP Snooping Information
To delete binding entries from the DHCP snooping binding database, use the no ip dhcp snooping
binding mac-address vlan vlan-id ip-address interface interface-id privileged EXEC command. Enter
this command for each entry that you want to delete.
Displaying DHCP Snooping Information
To display the DHCP snooping information, use one or more of the privileged EXEC commands in
Table 22-2 :
Note If DHCP snooping is enabled and an interface changes to the down state, the switch does not delete the
statically configured bindings.
Understanding IP Source Guard
IP source guard is a security feature that restricts IP traffic on nonrouted, Layer 2 interfaces by filtering
traffic based on the DHCP snooping binding database and on manually configured IP source bindings.
You can use IP source guard to prevent traffic attacks caused when a host tries to use the IP address of
its neighbor.
You can enable IP source guard when DHCP snooping is enabled on an untrusted interface. After IP
source guard is enabled on an interface, the switch blocks all IP traffic received on the interface, except
for DHCP packets allowed by DHCP snooping. A port access control list (ACL) is applied to the
interface. The port ACL allows only IP traffic with a source IP address in the IP source binding table
and denies all other traffic.
Note As with all port ACLs, this port ACL takes precedence over any router ACLs or VLAN maps that affect
the same interface.
The IP source binding table has bindings that are learned by DHCP snooping or are manually configured
(static IP source bindings). An entry in this table has an IP address, its associated MAC address, and its
associated VLAN number. The switch uses the IP source binding table only when IP source guard is
enabled.
IP source guard is supported only on Layer 2 ports, including access and trunk ports.You can configure
IP source guard with source IP address filtering or with source IP and MAC address filtering.
Table 22-2 Commands for Displaying DHCP Information
Command Purpose
show ip dhcp snooping Displays the DHCP snooping configuration for a switch
show ip dhcp snooping binding Displays only the dynamically configured bindings in the DHCP snooping binding
database, also referred to as a binding table.
show ip dhcp snooping database Displays the DHCP snooping binding database status and statistics.
show ip dhcp snooping statistics Displays the DHCP snooping statistics in summary or detail form.
show ip source binding Display the dynamically and statically configured bindings.