Dell POWEREDGE M1000E - Manual (Page 655)

28-5
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 28 Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LLDP, LLDP-MED, and Wired Location Service
• If you first configure a network-policy profile on an interface, you cannot apply the switchport
voice vlan command on the interface. If the switchport voice vlan vlan-id is already configured on
an interface, you can apply a network-policy profile on the interface. This way the interface has the
voice or voice-signaling VLAN network-policy profile applied on the interface.
• You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
• You cannot configure a network-policy profile on a private-VLAN port.
Enabling LLDP
Beginning in privileged EXEC mode, follow these steps to enable LLDP:
To disable LLDP, use the no lldp run global configuration command. To disable LLDP on an interface,
use the no lldp transmit and the no lldp receive interface configuration commands.
This example shows how to globally enable LLDP.
Switch# configure terminal
Switch(config)# lldp run
Switch(config)# end
This example shows how to enable LLDP on an interface.
Switch# configure terminal
Switch(config)# interface interface_id
Switch(config-if)# lldp transmit
Switch(config-if)# lldp receive
Switch(config-if)# end
Configuring LLDP Characteristics
You can configure the frequency of LLDP updates, the amount of time to hold the information before
discarding it, and the initialization delay time. You can also select the LLDP and LLDP-MED TLVs to
send and receive.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 lldp run Enable LLDP globally on the switch.
Step 3 interface interface-id Specify the interface on which you are enabling LLDP, and enter
interface configuration mode.
Step 4 lldp transmit Enable the interface to send LLDP packets.
Step 5 lldp receive Enable the interface to receive LLDP packets.
Step 6 end Return to privileged EXEC mode.
Step 7 show lldp Verify the configuration.
Step 8 copy running-config startup-config (Optional) Save your entries in the configuration file.