Dell POWEREDGE M1000E - Manual (Page 1179)

47-7
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 47 Troubleshooting
Recovering from a Lost or Forgotten Password
Procedure with Password Recovery Disabled
If the password-recovery mechanism is disabled, this message appears:
The password-recovery mechanism has been triggered, but
is currently disabled. Access to the boot loader prompt
through the password-recovery mechanism is disallowed at
this point. However, if you agree to let the system be
reset back to the default system configuration, access
to the boot loader prompt can still be allowed.
Would you like to reset the system back to the default configuration (y/n)?
Caution Returning the switch to the default configuration results in the loss of all existing configurations. We
recommend that you contact your system administrator to verify if there are backup switch and VLAN
configuration files.
• If you enter n (no), the normal bootup process continues as if the Mode button had not been pressed;
you cannot access the boot loader prompt, and you cannot enter a new password. You see the
message:
Press Enter to continue........
• If you enter y (yes), the configuration file in flash memory and the VLAN database file are deleted.
When the default configuration loads, you can reset the password.
Step 1 Elect to continue with password recovery and lose the existing configuration:
Would you like to reset the system back to the default configuration (y/n)? Y
Step 2 Load any helper files:
Switch: load_helper
Step 3 Display the contents of flash memory:
switch: dir flash:
The switch file system appears:
Directory of flash:
4 -rwx 9995193 Mar 1 1993 00:04:31 +00:00 cbs31x0-universal-mz.122-40.EX1.0
57931776 bytes total (35725824 bytes free)
Step 4 Boot up the system:
Switch: boot
You are prompted to start the setup program. To continue with password recovery, enter N at the prompt:
Continue with the configuration dialog? [yes/no]: N
Step 5 At the switch prompt, enter privileged EXEC mode:
Switch> enable
Step 6 Enter global configuration mode:
Switch# configure terminal
Step 7 Change the password:
Switch (config)# enable secret password