Dell POWEREDGE M1000E - Manual (Page 1051)

41-7
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 41 Configuring Cisco IOS IP SLAs Operations
Configuring IP SLAs Operations
Supported Operation Types
Type of Operation to Perform: 802.1agEcho
Type of Operation to Perform: 802.1agJitter
Type of Operation to Perform: dhcp
Type of Operation to Perform: dns
Type of Operation to Perform: echo
Type of Operation to Perform: ftp
Type of Operation to Perform: http
Type of Operation to Perform: jitter
Type of Operation to Perform: pathEcho
Type of Operation to Perform: pathJitter
Type of Operation to Perform: tcpConnect
Type of Operation to Perform: udpEcho
IP SLAs low memory water mark: 21741224
Configuring the IP SLAs Responder
The IP SLAs responder is available only on Cisco IOS software-based devices, including some Layer 2
switches that do not support full IP SLAs functionality, such as the Catalyst 2960 or the Cisco ME 2400
switch. Beginning in privileged EXEC mode, follow these steps to configure the IP SLAs responder on
the target device (the operational target):
To disable the IP SLAs responder, enter the no ip sla responder global configuration command. This
example shows how to configure the device as a responder for the UDP jitter IP SLAs operation in the
next procedure:
Switch(config)# ip sla responder udp-echo 172.29.139.134 5000
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 ip sla responder {tcp-connect |
udp-echo} ipaddress ip-address port
port-number Configure the switch as an IP SLAs responder.
The keywords have these meanings:
• tcp-connect—Enable the responder for TCP connect operations.
• udp-echo—Enable the responder for User Datagram Protocol (UDP)
echo or jitter operations.
• ipaddress ip-address—Enter the destination IP address.
• port port-number—Enter the destination port number.
Note The IP address and port number must match those configured on
the source device for the IP SLAs operation.
Step 3 end Return to privileged EXEC mode.
Step 4 show ip sla responder Verify the IP SLAs responder configuration on the device.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.