Dell POWEREDGE M1000E - Manual (Page 1068)

42-10
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 42 Configuring Enhanced Object Tracking
Monitoring Enhanced Object Tracking
This example shows how to configure and display IP SLAs state tracking:
Switch(config)# track 2 200 state
Switch(config)# end
Switch# show track 2
Track 2
Response Time Reporter 1 state
State is Down
1 change, last change 00:00:47
Latest operation return code: over threshold
Latest RTT (millisecs) 4
Tracked by:
HSRP Ethernet0/1 3
This example output shows whether a route is reachable:
Switch(config)# track 3 500 reachability
Switch(config)# end
Switch# show track 3
Track 3
Response Time Reporter 1 reachability
Reachability is Up
1 change, last change 00:00:47
Latest operation return code: over threshold
Latest RTT (millisecs) 4
Tracked by:
HSRP Ethernet0/1 3
Monitoring Enhanced Object Tracking
Use the privileged EXEC or user EXEC commands in Table 42-1 to display enhanced object tracking
information.
Table 42-1 Commands for Displaying Tracking Information
Command Purpose
show track [object-number] Display information about the all tracking lists or
the specified list.
show track brief Display a single line of tracking information
output.
show track interface [brief] Display information about tracked interface
objects.
show track ip [object-number] [brief] route Display information about tracked IP-route
objects.
show track resolution Display the resolution of tracked parameters.
show track timers Display tracked polling interval timers.