Dell POWEREDGE M1000E - Manual (Page 360)

12-2
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 12 Configuring Smartports Macros
Configuring Smartports Macros
Configuring Smartports Macros
You can create a new Smartports macro or use an existing macro as a template to create a new macro
that is specific to your application. After you create the macro, you can apply it globally to a switch or
to a switch interface or range of interfaces.
These sections contain this configuration information:
• Default Smartports Macro Configuration, page 12-2
• Smartports Macro Configuration Guidelines, page 12-2
• Creating Smartports Macros, page 12-4
• Applying Smartports Macros, page 12-5
• Applying Cisco-Default Smartports Macros, page 12-6
Default Smartports Macro Configuration
There are no Smartports macros enabled.
Smartports Macro Configuration Guidelines
Follow these guidelines when configuring macros on your switch:
• When creating a macro, do not use the exit or end commands or change the command mode by using
interface interface-id. This could cause commands that follow exit, end, or interface interface-id
to execute in a different command mode.
• When creating a macro, all CLI commands should be in the same configuration mode.
cisco-phone Use this interface configuration macro when connecting a desktop device such as a
PC with a Cisco IP Phone to a switch port. This macro is an extension of the
cisco-desktop macro and provides the same security and resiliency features, but with
the addition of dedicated voice VLANs to ensure proper treatment of delay-sensitive
voice traffic.
cisco-switch Use this interface configuration macro when connecting an access switch and a
distribution switch or between access switches connected using small form-factor
pluggable (SFP) modules.
cisco-router Use this interface configuration macro when connecting the switch and a WAN
router.
cisco-wireless Use this interface configuration macro when connecting the switch and a wireless
access point.
1. Cisco-default Smartports macros vary depending on the software version running on your switch.
Table 12-1 Cisco-Default Smartports Macros (continued)
Macro Name 1 Description