Enabling vtp version 2 – Dell POWEREDGE M1000E User Manual
Page 413
14-13
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 14 Configuring VTP
Configuring VTP
Note
You can also configure VTP transparent mode by using the vlan database privileged EXEC command
to enter VLAN database configuration mode and by entering the vtp transparent command, similar to
the second procedure under the
“Configuring a VTP Server” section on page 14-9
. Use the no vtp
transparent VLAN database configuration command to return the switch to VTP server mode. If
extended-range VLANs are configured on the switch, you cannot change VTP mode to server. You
receive an error message, and the configuration is not allowed.
Enabling VTP Version 2
VTP Version 2 is disabled by default on VTP Version 2-capable switches. When you enable VTP
Version 2 on a switch, every VTP Version 2-capable switch in the VTP domain enables Version 2. You
can only configure the version when the switches are in VTP server or transparent mode.
Caution
VTP Version 1 and VTP Version 2 are not interoperable on switches in the same VTP domain. Every
switch in the VTP domain must use the same VTP version. Do not enable VTP Version 2 unless every
switch in the VTP domain supports Version 2.
Note
In TrCRF and TrBRF Token ring environments, you must enable VTP Version 2 for Token Ring VLAN
switching to function properly. For Token Ring and Token Ring-Net media, VTP Version 2 must be
disabled.
For more information on VTP version configuration guidelines, see the
.
Beginning in privileged EXEC mode, follow these steps to enable VTP Version 2:
To disable VTP Version 2, use the no vtp version global configuration command.
Note
You can also enable VTP Version 2 by using the vlan database privileged EXEC command to enter
VLAN database configuration mode and by entering the vtp v2-mode VLAN database configuration
command. To disable VTP Version 2, use the no vtp v2-mode VLAN database configuration command.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
vtp version 2
Enable VTP Version 2 on the switch.
VTP Version 2 is disabled by default on VTP Version 2-capable switches.
Step 3
end
Return to privileged EXEC mode.
Step 4
show vtp status
In the VTP V2 Mode field of the display, verify that VTP Version 2 is enabled.