Dell POWEREDGE M1000E - Manual (Page 708)

32-4
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 32 Configuring System Message Logging
Configuring System Message Logging
*Mar 1 18:46:11: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
18:47:02: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
*Mar 1 18:48:50.483 UTC: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Default System Message Logging Configuration
Table 32-2 shows the default system message logging configuration.
Disabling Message Logging
Message logging is enabled by default. It must be enabled to send messages to any destination other than
the console. When enabled, log messages are sent to a logging process, which logs messages to
designated locations asynchronously to the processes that generated the messages.
Beginning in privileged EXEC mode, follow these steps to disable message logging. This procedure is
optional.
Table 32-2 Default System Message Logging Configuration
Feature Default Setting
System message logging to the console Enabled.
Console severity Debugging (and numerically lower levels; see
Table 32-3 on page 32-10 ).
Logging file configuration No filename specified.
Logging buffer size 4096 bytes.
Logging history size 1 message.
Time stamps Disabled.
Synchronous logging Disabled.
Logging server Disabled.
Syslog server IP address None configured.
Server facility Local7 (see Table 32-4 on page 32-14 ).
Server severity Informational (and numerically lower levels; see
Table 32-3 on page 32-10 ).
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 no logging console Disable message logging.
Step 3 end Return to privileged EXEC mode.
Step 4 show running-config
or
show logging
Verify your entries.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.