Dell POWEREDGE M1000E - Manual (Page 476)

18-18
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 18 Configuring STP
Configuring Spanning-Tree Features
Configuring a Secondary Root Switch
When you configure a switch as the secondary root, the switch priority is modified from the default value
(32768) to 28672. The switch is then likely to become the root switch for the specified VLAN if the
primary root switch fails. This is assuming that the other network switches use the default switch priority
of 32768 and therefore are unlikely to become the root switch.
You can execute this command on more than one switch to configure multiple backup root switches. Use
the same network diameter and hello-time values that you used when you configured the primary root
switch with the spanning-tree vlan vlan-id root primary global configuration command.
Beginning in privileged EXEC mode, follow these steps to configure a switch to become the secondary
root for the specified VLAN. This procedure is optional.
To return to the default setting, use the no spanning-tree vlan vlan-id root global configuration
command.
Configuring Port Priority
If a loop occurs, spanning tree uses the port priority when selecting an interface to put into the
forwarding state. You can assign higher priority values (lower numerical values) to interfaces that you
want selected first and lower priority values (higher numerical values) that you want selected last. If all
interfaces have the same priority value, spanning tree puts the interface with the lowest interface number
in the forwarding state and blocks the other interfaces.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 spanning-tree vlan vlan-id root secondary
[diameter net-diameter [hello-time
seconds]] Configure a switch to become the secondary root for the specified
VLAN.
• For vlan-id, you can specify a single VLAN identified by VLAN
ID number, a range of VLANs separated by a hyphen, or a series
of VLANs separated by a comma. The range is 1 to 4094.
• (Optional) For diameter net-diameter, specify the maximum
number of switches between any two end stations. The range is
2 to 7.
• (Optional) For hello-time seconds, specify the interval in
seconds between the generation of configuration messages by
the root switch. The range is 1 to 10; the default is 2.
Use the same network diameter and hello-time values that you used
when configuring the primary root switch. See the
“Configuring the
Root Switch” section on page 18-16 .
Step 3 end Return to privileged EXEC mode.
Step 4 show spanning-tree detail Verify your entries.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.