Dell POWEREDGE M1000E - Manual (Page 126)

4-18
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
Chapter 4 Configuring Cisco EnergyWise
Additional Information
Additional Information
• Managing Power in a LAN, page 4-18
• Managing Power with IP Routing, page 4-18
Managing Power in a LAN
Multiple switches connected in the same LAN and in the same EnergyWise domain.
Figure 4-4 EnergyWise with LANs
The domain configuration includes
• UDP default port (43440)
• Gigabit Ethernet port 1/0/23 on Switch 2 with a connected Catalyst PoE switch.
On Switch 1, configure the domain:
Switch(config): energywise domain cisco secret 0 cisco protocol udp port 43440 interface
gigabitethernet1/0/23
On Switch 1, verify that the EnergyWise protocols discovered the neighbors:
Switch# show energywise neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone
Id Neighbor Name Ip:Port Prot Capability
-- ------------- ------- ---- ----------
4 Switch-2 192.168.20.2:43440 udp S I
Managing Power with IP Routing
Switch 1 and Switch 2 are in a disjointed domain. Neighbors might not be discovered automatically.
Switch 1 Switch 2
Catalyst PoE switch
Port 24 Port 1
Port 23
Port 24
205694