Configuring web cache services by using wccp, C h a p t e r – Dell POWEREDGE M1000E User Manual
Page 1069
C H A P T E R
43-1
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-13270-03
43
Configuring Web Cache Services By Using
WCCP
This chapter describes how to configure your switch to redirect traffic to wide-area application engines
(such as the Cisco Cache Engine 550) by using the Web Cache Communication Protocol (WCCP). This
software release supports only WCCP Version 2 (WCCPv2).
WCCP is a Cisco-developed content-routing technology that you can use to integrate wide-area
application engines—referred to as application engines—into your network infrastructure. The
application engines transparently store frequently accessed content and then fulfill successive requests
for the same content, eliminating repetitive transmissions of identical content from web servers.
Application engines accelerate content delivery and ensure maximum scalability and availability of
content. In a service-provider network, you can deploy the WCCP and application engine solution at the
points of presence (POPs). In an enterprise network, you can deploy the WCCP and application engine
solution at the regional site and the small branch office. To use this feature, the switch or the stack master
must be running the IP services feature set.
Unless otherwise noted, the term switch refers to a standalone switch and to a switch stack.
Note
For complete syntax and usage information for the commands used in this chapter, see the “WCCP
Router Configuration Commands” section in the “System Management Commands” part of the Cisco
IOS Configuration Fundamentals Command Reference, Release 12.2.
This chapter consists of these sections:
•
•
•